4-8 L90 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUALENERVISTA SOFTWARE INTERFACE CHAPTER 4: INTERFACES43. Enter the template password then click OK to apply the template.Once the template has been applied, users are limited to view and edit the settings specified by the template. The effect ofapplying the template to the phase time overcurrent settings is shown.Figure 4-6: Applying templates using the View in Template Mode commandViewing the settings in template mode also modifies the settings menu, showing only the settings categories that containeditable settings. The effect of applying the template to a typical settings menu is shown as follows.Figure 4-7: Applying templates using the View in Template Mode settings commandUse the following procedure to display settings available for editing and settings locked by the template.1. Select an installed device or a settings file from the tree menu on the left of the EnerVista UR Setup main screen.2. Apply the template by selecting the Template Mode > View All Settings option.3. Enter the template password then click OK to apply the template.Once the template has been applied, users are limited to edit the settings specified by the template, but all settings areshown. The effect of applying the template to the phase time overcurrent settings is shown as follows.
