Masoneilan SVI II ESD Installation and Maintenance Manual =| 69© 2016 General Electric Company. All rights reserved.Dismantling the SVI II ESD from Reciprocating ValvesWARNING Before carrying out any work on the device, power off theinstrument or ensure that the local conditions for potentiallyexplosive atmosphere permit the safe opening of the cover.To remove the SVI II ESD PST controller from a reciprocating valve perform Steps 1 - 12 in thereverse order.Checking the MagnetThere are two methods of checking the SVI II ESD magnet: Perform a visual inspection Use ValVue ESD to check the magnetPerforming a Visual InspectionTo perform a visual inspection refer to Table 5 on page 63 and ensure that the magnet iscorrectly oriented for the actuator/valve configuration.Using ValVue ESD to Check Magnet PositionUse this procedure to check the magnet using ValVue ESD (provided with SVI II ESD). Also referto Table 5 on page 63 for sensor information.1. Connect to the PST controller in accordance with the ValVue ESD instructions. For furtherinformation refer to the ValVue ESD On Line Help or Instruction Manual.2. After the PST controller has been installed and set up with a HART ® Modem in a HART ®compliant communications loop, install ValVue ESD on the computer that is connected tothe HART ® modem.3. Run ValVue ESD.4. Select the installed ESD PST controller from the list of Connected Devices as shown inFigure 49 and click Connect.5. Select the: Check tab to view the current operating conditions of the selected PSTcontroller.6. Read Raw Position Data on the Check screen as shown in Figure 49.7. The Raw Position Sensor value measured must in accordance with the Table 5 onpage 63.
