GE Masoneilan SVI II ESD Installation And Maintenance Manual

Contents

GE Masoneilan SVI II ESD Installation And Maintenance Manual Manual pdf 87 page image

© 2016 General Electric Company. All rights reserved. Masoneilan SVI II ESD Installation and Maintenance Manual =| 875. Configuration andCalibrationOverviewThis section provides information on SVI II ESD setup and calibration procedures to ensureproper valve positioning.SVI II ESD SetupPushbuttons and local display are thoroughly described in “Pushbuttons and Local Display” onpage 98 of this manual.Using the Pushbuttons and DisplayWhen configuring or calibrating a valve equipped with SVI II ESD, using the pushbutton display,the following steps are recommended:1. Change mode to Manual mode.2. Examine and adjust all Configuration items.3. Enter Calibration mode.4. Run Stops to automatically calibrate stroke.5. Run Auto Tune to set dynamic response.6. Examine device Status.7. Introduce manual set point changes to verify dynamic performance.You should perform setup and calibration procedures in this section before puttingthe SVI II ESD into operation as the SIF.NOTE