Courier Text Col Row Default Setting Available OptionsDescriptionCtrl Command 31 13 89 SET/RESET 0 = On/Off, 1 = Set/Reset, 2 = In/Out,3 = Enabled/DisabledThis setting allows you to select the text to be displayed on the hotkey menu.Control Input 32 13 8C Latched 0 = Latched or 1 = PulsedThis setting configures the control input as either ‘latched’ or ‘pulsed’.Ctrl Command 32 13 8D SET/RESET 0 = On/Off, 1 = Set/Reset, 2 = In/Out,3 = Enabled/DisabledThis setting allows you to select the text to be displayed on the hotkey menu.5.5.3 CONTROL INPUT LABELSIn the CTRL I/P LABELS column, you can define the text identifiers for the control inputs.Menu Text Col Row Default Setting Available OptionsDescriptionCTRL I/P LABELS 29 00This column contains settings for the Control Input LabelsControl Inputs 1 to 32 29 01 to 20 Control Input (n) Extended ASCII text (characters 32 to 234 inclusive)In this cell you can enter a text label to describe the control input. This text is displayed when a control input is accessed by the hotkey menu andin the programmable scheme logic description of the control input.5.5.4 CONTROL INPUT DDB SIGNALSThe number of inputs depends on the model and they are connected to DDB signals as shown in thefollowing table. The default names are provided, but note that these can be configured in the CTRL I/PLABELS column.Ordinal Signal Name Source Type ResponseDescription1376 to 1407 Control Input (n) Software Control Protection eventThis DDB signal is a control input signalChapter 6 - Monitoring and Control MiCOM P747186 P747-TM-EN-1
