PRPIf using PRP, configure the IP address of the redundant Ethernet board using the PRP Configuratorsoftware.RSTPIf using RSTP, configure the IP address of the redundant Ethernet board using the RSTP Configuratorsoftware and DIP switches on the board.SHP or DHPIf using SHP or DHP configure the IP address of the redundant Ethernet board using the Switch Managersoftware and DIP switches on the board.6.2.1 CONFIGURING THE FIRST TWO OCTETS OF THE BOARD IP ADDRESSIf using PRP, the first two octets are configured using the PRP Configurator software tool.If using SHP or DHP, the first two octets are configured using the Switch Manager software tool or an SNMPMIB browser. An H35 (SHP) or H36 (DHP) network device is needed in the network to configure the Px40redundant Ethernet board IP address using SNMP.If using RSTP, the first two octets are configured using the RSTP Configurator software tool or using anSNMP MIB browser.6.2.2 CONFIGURING THE THIRD OCTET OF THE BOARD IP ADDRESSThe third octet is fixed at 254 (FE hex, 11111110 binary) for SHP, DHP and RSTP. However, for PRP it isset using the PRP Configurator.6.2.3 CONFIGURING THE LAST OCTET OF THE BOARD IP ADDRESSIf using PRP, the last octet is configured using the PRP Configurator software tool.If using SHP, DHP or RSTP, the last octet is configured using board address switch SW2 on the board.Remove the IED front cover to gain access to the board address switch.Warning:Configure the hardware settings before the unit is installed.1. Refer to the safety section of the IED.2. Switch off the IED. Disconnect the power and all connections.3. Before removing the front cover, take precautions to prevent electrostatic discharge damageaccording to the ANSI/ESD-20.20 -2007 standard.MiCOM P747 Chapter 8 - Redundant EthernetP747-TM-EN-1 259
