Before gou call for service...Troubleshooting TipsSave time and moneg! Review the charts on the followingpages first and gou meg not need to call for service.Surface elements will notmaintain a rolling boilor cooking is slowPossible CausesImproper cookwarebeing used.What To Do• Use pans that are recommended for induction, haveflat bottoms and match the size of the surface element.Surface elements do Cooktop controls • Check to be sure the correct control is set for thenot work properlg improperlg set. surface element you are using.Flashing "F" Wrong pan tgpe. • Use a magnet to check that cookware is inductioncompatible.Pan is too small. • Flashing "F" pan size is below the minimum size forthe element. See the Using the correct size cookworesection.Pan not positioned correctly. • Center the pan in the cooking ring.Scratches on cooktop Incorrect cleaning methods • Use recommended cleaning procedures. Seetheglass surface being used. Cleaning the glass cooktop section.Cookware with rough bottoms •being used or coarse particles(salt or sand) were betweenthe cookware and the surfaceof the cooktop.Cookware has been slidacross the cooktop surface.To avoid scratches, use the recommended cleaningprocedures. Make sure bottoms of cookware are cleanbefore use, and use cookware with smooth bottoms.Areas of discoloration Food spillovers not cleaned • See the Cleaning the gloss cooktop section.on the cooktop before next use.Hot surface on a model • This is normal. The surface may appear discoloredwith a light-colored glass when it is hot. This is temporary and will disappearcooktop, as the glass cools.Plastic melted to Hot cooktop came into • See the Glass surface - potential for permanent damagethe surface contact with plastic placed section in the Cleaning the gloss cooktop section.on the hot cooktop.Pitting (or indentation) Hot sugar mixture spilled • Call a qualified technician for replacement.of the cooktop on the cooktop.Unresponsive kegpad Kegpad is dirtg. • Clean the keypad.A fuse in gour home mag be • Replace the fuse or reset the circuit breaker.blown or the circuit breakertripped.18