GE Profile 164D3370P003 Owner's Manual

47If Something Goes WrongBefore You Call For ServiceOven will notstart“PLEASE INSERTPROBE “ appearson display“SENSOR ERROR”appears on displayFloor of the oven iswarm, even whenthe oven has notbeen used“BAD PROBE”appears on display“LOCKED” appearson displayFood amount toolarge for SensorReheatWhen using a Sensor • Do not open door until steam isfeature, the door was sensed and time is shown countingopened before steam down on display.could be detected.Steam was not detected • Use Micro Cook to heat for more time.in maximum amount oftime.Problem Possible Cause What to DoA fuse in your home • Replace fuse or reset circuit breaker.may be blown or thecircuit breaker tripped.Power surge. • Unplug the microwave oven, then plugit back in.Plug not fully inserted • Make sure the 3-prong plug on theinto wall outlet. oven is fully inserted into wall outlet.Probe has been • Insert the probe properly into the wallforgotten or not receptacle.inserted properly.The cooktop light is • This is normal.located below the ovenfloor. When the lightis on, the heat itproduces may make theoven floor get warm.The probe has not been • Insert the probe properly into the wallcompletely inserted receptacle.into the wall receptacle.The probe is defective. • Replace the probe.The control has been • Press and hold CLEAR/OFF forlocked. about 3 seconds to unlock the control.Sensor Reheat is for • Use Micro Cook for large amountssingle servings of of food.recommended foods.