GE WE25M46 Installation Instructions Manual

Also see for Profile WE25M46: Dimensions and installation information

REMOVE THE FRONT AND TOP1. Disconnect gas inlet from the dryer. Unscrew gasflexible connector or gas pipe line.2. Remove the rotary knob by pulling straight out.3. Remove the Phillips-head screw located insidethe control knob recess.4. Raise the control panel vertically to disengage thefour key slots from the four grommets.ENTERS TEAM REFRESHSPEED DRYWARM UPA CTIVE WEARWRINKLE FREEDELICATESN ORMAL /M IXED L OADSSENSOR DRYTIME DRYC OTTONSSPECIALTYC YCLEST IMED DRYSTEAMDEWRINKLERemovescrew06-11 GE Printed in MexicoInstallation Instructions31-16671BEFORE YOU BEGINRead these instructions completely and carefully.This kit contains the necessary parts for conversion,from Natural Gas to LP (Propane) Gas, of GE Dryermodels with “KIT M46” specified on the rating plate.PARTS INCLUDED IN THE KIT• Gas Valve for LP (Propane) Gas• Instructions (English, French & Spanish)• Conversion Rating Plate (English/French/Spanish)• Responsibility Label (English/French/Spanish)WARNING: This conversion kit shall beinstalled by a qualified service agency inaccordance with the manufacturer’s instructions,CAN/CGA-B149-1 and CAN/CGA-B149-2installation codes and the requirements of theauthorities having jurisdiction. The information inthese instructions must be followed to minimizethe risk of fire or explosion or to prevent propertydamage, personal injury or death. The qualifiedservice agency is responsible for the properinstallation of this kit. The installation is not properand complete until the operation of the convertedappliance is checked as specified in themanufacturer’s instruction supplied with the kit.GAS VALVE FOR LP (PROPANE) GAS• The valve is equipped with a nozzle #54 (1.4 mmdia. (0.055” dia.) orifice and a pressure regulator setat 22.35±0.7cm (8.8±0.3”) of water column for anoutput energy of 21,400 BTU/hr on LP (Propane) gas.• Required inlet pressure: minimum 22.89 cm (9.0”)of water, maximum 35.5 cm (14.0”) of water.• For operation at elevation above 610 m (2,000ft), input rating should be reduced at a rate of 4percent for each 305 m (1,000 ft) above sea level.IMPORTANT SAFETY NOTICE:This information is intended for use by individualspossessing adequate backgrounds of electrical,electronic and mechanical experience. Anyattempt to repair a major appliance may result inpersonal injury and property damage. Neither themanufacturer nor the seller can be responsible forthe interpretation of this information or any liability inconnection with its use.LP (PROPANE) GASCONVERSION KIT - WE25M46STEP 11/8 NPT manifoldpressure tap NotvisibleAutomatic valveDual Coil, 2ndStage1stStageCoilGas PipeBracketBurnerWARNING:Before beginning the installation, turn off thecircuit breaker(s) or remove the dryer’s circuitfuse(s) at the electrical box. Be sure the dryer cordis unplugged from the wall.Turn the dryer’s gas shutoff valve in the supplyline to the OFF position.ENTERS TEAMREFRESHSPEED DRYWARM UPA CTIVE WEARWRINKLE FREEDELICATESN ORMAL /M IXED L OADSSENSOR DRYTIME DRYC OTTONSSPECIALTYCYCLEST IMED DRYSTEAMDEWRINKLEPull knobstraightout andoffLift andremove1