GE WE25M46 Installation Instructions Manual

Also see for Profile WE25M46: Dimensions and installation information

10. Disconnect the electrical power when completed.11. Reinstall the test plug in the manifold pressuretap.12. Reassemble the drum into dryer.13. Replace the belt removed earlier.• Push the left arm to the left (appx. 1 inch)• Route the belt on the right side of the idler pulleyand under the motor pulley• Slowly release the left idler arm and push theright idler arm to the right• Place the belt on the left side of the right idlerpulley• Slowly release the right idler arm until the belt istaut• Slowly turn drum by hand to ensure belt isaligned and not twisted14. Remount front and top.15. Reconnect the electrical power and start thedryer. Flame appearance may be observed byusing a mirror and looking through the viewerlocated in the base on the right side.Flame observation (side panel removed for viewingpurpose)16. Open dryer door. Apply the Conversion RatingPlate on the lower right corner of the dooropening, and the Responsibility Label on thelower left corner.COMPLETE INSTALLATION• Complete the installation by following the InstallationInstructions that came with the dryer.STEP 54MirrorRight side