Gaggenau BS 470 Instruction Manual

Also see for BS 470: Installation instructions Use and care manual Instruction manual Instruction manual

Contents

Gaggenau BS 470 Instruction Manual Manual pdf 15 page image

15Ending initial set-up"Initial set-up complete. Please calibrate the appliancebefore first cooking." appears in the display.Confirm with ™.The appliance enters standby mode and the standbyscreen appears. The appliance is now ready foroperation.Calibrate the appliance before steaming for the firsttime. The appliance sets the boiling point.CalibrationThe boiling point of water depends on barometricpressure. As air pressure drops with increasingelevation, the boiling point drops as well. Duringcalibration, the appliance sets the boiling point to thepressure conditions at the place where it is installed.It is important that the appliance steams withoutinterruption for 20 minutes at 100°C. Do not open theappliance door during this time.Notes‒ Calibrate the appliance only when it is cold.‒ During calibration, the appliance generates moresteam than it normally would do.1 Turn the function selector to S.2 Select "Basic settings" using the rotary selector.3 Touch the ™ symbol.4 Select "Calibration" using the rotary selector.5 Touch the % symbol.6 Remove all accessories from the oven interior andtouch the ™ symbol.7 The duration of 20:00 minutes appears. Touch I tostart calibration.Calibration begins. The elapsing time is shown on thedisplay.Note: Do not interrupt calibration. Do not turn thefunction selector. Do not open the appliance door.A message appears in the display once calibration hasended. Touch ™ to confirm and turn the functionselector to 0.After moving houseRepeat calibration so that the appliance adaptsautomatically to the new installation location.After resetting to the factory settingsAfter resetting to the factory settings in the basicsettings menu, you must repeat calibration.Following a power cutThe appliance saves the calibration settings even in theevent of a power cut or disconnection from the mains.Recalibration is not necessary.Cleaning accessoriesBefore using the accessories for the first time, cleanthem thoroughly using hot detergent solution and a softcloth.3OHDVHFDOLEUDWHWKHDSSOLDQFHEHIRUHILUVWFRRNLQJ,QLWLDOVHWXSFRPSOHWH&DOLEUDWLRQ&$/&$/