Garmin Edge 820 Owner's Manual

Also see for Edge 820: Owner's manual Owner's manual

Garmin Edge 820 Owner's Manual Manual pdf 5 page image

IntroductionWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.Always consult your physician before you begin or modify anyexercise program.Getting StartedWhen using your device the first time, you should completethese tasks to set up the device and learn about the basicfeatures.1 Charge the device (Charging the Device, page 1).2 Install the device using the standard mount (Installing theStandard Mount, page 1) or the out-front mount (Installingthe Out-Front Mount, page 1).3 Turn on the device (Turning On the Device, page 2).4 Locate satellites (Acquiring Satellite Signals, page 2).5 Go for a ride (Going for a Ride, page 3).6 Upload your ride to Garmin Connect™ (Sending Your Ride toGarmin Connect, page 15).Charging the DeviceNOTICETo prevent corrosion, thoroughly dry the USB port, the weathercap, and the surrounding area before charging or connecting toa computer.The device is powered by a built-in lithium-ion battery that youcan charge using a standard wall outlet or a USB port on yourcomputer.NOTE: The device will not charge when outside the approvedtemperature range (Edge Specifications, page 19).1 Pull up the weather cap À from the USB port Á.2 Plug the small end of the USB cable into the USB port on thedevice.3 Plug the large end of the USB cable into an AC adapter or acomputer USB port.4 Plug the AC adapter into a standard wall outlet.When you connect the device to a power source, the deviceturns on.5 Charge the device completely.About the BatteryWARNINGThis device contains a lithium-ion battery. See the ImportantSafety and Product Information guide in the product box forproduct warnings and other important information.Installing the Standard MountFor the best GPS reception, position the bike mount so the frontof the device is oriented toward the sky. You can install the bikemount on the stem or the handlebars.1 Select a secure location to mount the device where it doesnot interfere with the safe operation of your bike.2 Place the rubber disk À on the back of the bike mount.The rubber tabs align with the back of the bike mount so itstays in place.3 Place the bike mount on the bike stem.4 Attach the bike mount securely using the two bands Á.5 Align the tabs on the back of the device with the bike mountnotches Â.6 Press down slightly and turn the device clockwise until itlocks into place.Installing the Out-Front Mount1 Select a secure location to mount the Edge device where itdoes not interfere with the safe operation of your bike.2 Use the hex key to remove the screw À from the handlebarconnector Á.3 If necessary, remove the two screws on the back side of themount Â, rotate the connector Ã, and replace the screws tochange the orientation of the mount.4 Place the rubber pad around the handlebar:• If the handlebar diameter is 25.4 mm, use the thicker pad.• If the handlebar diameter is 31.8 mm, use the thinner pad.5 Place the handlebar connector around the rubber pad.6 Replace and tighten the screw.NOTE: Garmin®recommends a torque specification of 7 lbf-in. (0.8 N-m). You should check the tightness of the screwperiodically.7 Align the tabs on the back of the Edge device with the bikemount notches Ä.Introduction 1