Garmin G1000 Cockpit Reference Guide for the Columbia 350/400190-00567-01 Rev. A 9-3SECTION 9 – PROCEDURESLoad and/or Activate an Approach Procedure1) Press the PROC Key.2) Turn the large FMS Knob to highlight ‘SELECTAPPROACH’.3) Press the ENT Key.4) If a flight plan is active, the destination airportwill be displayed as the default. A list of availableapproaches is also displayed. If no flight plan isactive, use the FMS Knobs to enter the identifier ofthe desired airport. Press the ENT Key.5) Turn the large FMS Knob to highlight the Approachfield. Turn the small FMS Knob to display a list ofavailable approaches.Figure 9-6 Selecting an Approach Procedure6) Turn either FMS Knob to highlight the desiredapproach. Press the ENT Key.7) The cursor will move to the TRANSITIONS field.Turn the large FMS Knob to highlight the desiredtransition waypoint and press the ENT Key. (The“Vectors” option assumes vectors will be receivedto the final course segment of the approach andwill provide navigation guidance relative to the finalapproach course.)Figure 9-7 Selecting an Approach Transition8) Turn the large FMS Knob to highlight ‘Activate?’and press the ENT Key to activate the approach.Selecting ‘Load?’ will add the procedure tothe flight plan without immediately using it fornavigation guidance.Activate An Approach in the Active Flight Plan1) With the Navigation Map Page displayed, press thePROC Key.2) Turn the large FMS Knob to highlight ‘ACTIVATEAPPROACH’.3) Press the ENT Key. The approach procedure is nowactive.
