GIA 63 Installation Manual 190-00303-05Page 3-2 Rev. Y3.2 Wiring Harness InstallationAllow adequate space for installation of cables and connectors. The installer shall supply and fabricate allof the cables. All electrical connections are made through 44, 62, and 78-pin D subminiature connectors.Section 4 defines the electrical characteristics of all input and output signals. Required connectors andassociated hardware are supplied with the connector kit.See Appendix C for examples of interconnect wiring diagrams. Construct the actual harnesses inaccordance with aircraft manufacturer authorized interconnect standards.1. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject tochange without notice.2. Extraction of 16 and 18 AWG contacts requires that the expanded wire barrel be cut off from thecontact. It may also be necessary to push the pin out from the face of the connector when using anextractor due to the absence of the wire. A new contact must be used when reassembling theconnector.3. For applications using 16 AWG wire, contact Garmin for information regarding connector crimppositioner tooling.Table 3-1. Pin Contact Part NumbersManufacturer78 pin connectors (P603, 605, 606), 62 pin connectors (P602), 44 pinconnectors (P604 and P601)16 AWG(Power Only)18-20 AWG(Power Only) 22-28 AWGGarmin P/N 336-00044-01 336-00044-00 336-00021-00Military P/N N/A N/A M39029/58-360AMP N/A N/A 204370-02Positronic N/A N/A MC8522DTable 3-2. Recommended Crimp ToolsManufacturer HandCrimping Tool18-20 AWG 22-28 AWGPositionerInsertion/Extraction Tool(Note 2)PositionerInsertion/ExtractionToolMilitary P/N M22520/2-01 N/A M81969/1-04 M22520/2-09 M81969/1-04Positronic 9507 9502-11 M81969/1-04 9502-3 M81969/1-04AMP 601966-1 N/A 91067-1 601966-6 91067-1Daniels AFM8 K774 M81969/1-04 K42 M81969/1-04Astro 615717 N/A M81969/1-04 615725 M81969/1-04NOTES