GIA 63 Installation Manual Page 3-1190-00303-05 Revision T3 INSTALLATION PROCEDURE3.1 Unpacking UnitCarefully unpack the equipment and make a visual inspection of the unit for evidence of damage incurredduring shipment. If the unit is damaged, notify the carrier and file a claim. To justify a claim, save theoriginal shipping container and all packing materials. Do not return the unit to Garmin until the carrierhas authorized the claim.Retain the original shipping containers for storage. If the original containers are not available, a separatecardboard container should be prepared that is large enough to accommodate sufficient packing materialto prevent movement.3.2 Wiring Harness InstallationAllow adequate space for installation of cables and connectors. The installer shall supply and fabricate allof the cables. All electrical connections are made through 44, 62, and 78-pin D subminiature connectors.Section 4 defines the electrical characteristics of all input and output signals. Required connectors andassociated hardware are supplied with the connector kit.See Appendix C for examples of interconnect wiring diagrams. Construct the actual harnesses inaccordance with aircraft manufacturer authorized interconnect standards.Table 3-1. Pin Contact Part Numbers78 pin connectors (P603, 605, 606), 62 pin connectors (P602), 44 pinconnectors (P604 and P601)Manufacturer16 AWG(Power Only)18-20 AWG(Power Only)22-28 AWGGarmin P/N 336-00044-01 336-00044-00 336-00021-00Military P/N N/A N/A M39029/58-360AMP N/A N/A 204370-2Positronic N/A N/A MC8522DITT Cannon N/A N/A 030-2042-000Table 3-2. Recommended Crimp Tools18-20 AWG 22-28 AWGManufacturer HandCrimping Tool Positioner Insertion/Extraction Tool(note 2)Positioner Insertion/ExtractionToolMilitary P/N M22520/2-01 N/A M81969/1-04 M22520/2-09 M81969/1-04Positronic 9507 9502-11 M81969/1-04 9502-4 M81969/1-04ITT Cannon 995-0001-584 N/A N/A M22520/2-09 274-7048-000AMP 601966-1 N/A 91067-1 601966-6 91067-1Daniels AFM8 K774 M81969/1-04 K42 M81969/1-04Astro 615717 N/A M81969/1-04 615725 M81969/1-04DRAFT Rev T 11/12/2010