Page A-2 GIA 63 Installation ManualRevision T 190-00303-0510. Use the FMS knob to highlight GIA 6X software.11. Press the LRU softkey and highlight ‘GIA 1’.12. Press the ENT key to begin loading software.13. The boot block version should now appear on the MFD.14. If GIA main boot block version is 4.00 or earlier press the CANCEL softkey on the PFD andselect ‘YES’ at the prompt. Continue to Section A.3 for instructions on loading GIA main bootblock version 4.01.NOTEIf GIA main boot block version is 4.01, do not cancel the software upload.15. Repeat steps 7 through 13 for GIA 2.A.3 Loading Boot Block Version 4.011. Remove power from the PFD only.NOTEIf power is removed from the entire G1000 system GIA 2 may appear as GIA 1.2. Insert the GIA 63 boot block version 4.01 loader card into the top slot of the PFD.3. While holding the ENT key on the PFD, restore power to the PFD.4. When the words appear in the upper left corner of the PFD,release the ENT key.5. Use the FMS knob to turn to the Software Upload page on the PFD.6. Verify ‘GIA 6X Boot Block 4.01’ appears in the File List.7. Verify ‘GIA 1’ and ‘GIA 2’ appears in the LRU window.8. Press the FMS knob to highlight ‘GIA 6X Boot Block 4.01’.9. Press the LOAD softkey.10. Press the ENT key at the “BEGIN FILE UPLOAD?” prompt.CAUTIONDo not turn power off or cancel the software upload while the boot block is loading.DRAFT Rev T 11/12/2010