6 190-00607-02 Rev CDetailed OperationSelect AirportThe Select Airport operation allows the airport ofinterest to be selected from a pop-up list. The airportspresented in the list are determined based on the des-tination waypoint as the first entry, and a nearest typesearch for the remaining entries. This method allowsthe airport to be quickly located based on the currentflight plan on the external GPS navigator.Selecting an Airport from a list in the Chart FunctionOnce the airport is located, the Select Chart menuis presented (see below), allowing a specific chart forthat airport to be either loaded or simply viewed.Select ChartThe Select Chart operation allows the list of chartsfor the currently selected airport to be listed in apop-up list. Within this list, a circular earth symbolindicates that the chart is geo-referenced and thereforecan be loaded for use as an overlay on the maps. If ared “X” is presented through the earth symbol, thenthat specific chart is not geo-referenced and can beviewed, but not loaded as a map overlay.Selecting a Chart from a list in the Chart FunctionView LoadedThe Select Loaded operation allows the currentlyloaded chart to be selected for viewing. This is typicallydone if a given chart was LOADED from the Custom/IFR Map, and viewing it from the ChartView Function isdesired. Note that loading a chart from the Custom/IFRMap will also load and select the chart for viewing.Load to MapThe Load Current operation allows the current(viewed) approach chart to be set as the LOADEDapproach chart. When this operation is performed,any previously loaded chart is replaced with the chartthat is currently being viewed.Load the Current Chart for ViewingChartView - Chart
