Garmin GPSMAP 190-01120-00 Owner's Manual

Also see for GPSMAP 6008: Technical reference Important safety information Supplement Owner's manual Declaration of conformity

Contents

Garmin GPSMAP 190-01120-00 Owner's Manual Manual pdf 124 page image

GPSMAP® 6000/7000 Series Owner’s ManualAppendixSetting Decimal Precision for NMEA 0183 OutputYou can adjust the number of digits to the right of the decimal point for transmission of NMEAoutput.1. From the Home screen, select Configure > Communications > NMeA 0183 Setup > Posn.Precision.2. Select two Digits, three Digits, or Four Digits.Setting Waypoint Labels for NMEA 0183 OutputYou can configure how the chartplotter provides waypoint identifiers.1. From the Home screen, select Configure > Communications > NMeA 0183 Setup > WaypointIDs.2. Select Names or Numbers.Resetting NMEA 0183 Communication Default SettingsYou can reset NMEA 0183 settings to their default values.From the Home screen, select Configure > Communications > NMeA 0183 Setup > Defaults> oK.Viewing NMEA 0183 Diagnostic InformationThe NMEA 0183 Diagnostics screen is a troubleshooting tool used by installers to verify that NMEA0183 data is being sent across the system.From the Home screen, select Configure > Communications > NMeA 0183 Setup >Diagnostics.NMEA 2000GPSMAP 6000/7000 series chartplotters are NMEA 2000 certified and can receive data from aNMEA 2000 network installed on the boat to show specific information on the Information screen,such as depth, speed, water temperature, wind speed and direction, and engine data.To connect a GPSMAP 6000/7000 series chartplotter to an existing NMEA 2000 network and tosee a list of supported NMEA 2000 PGN numbers, see the GPSMAP 6000/7000 Series InstallationInstructions.Viewing a List of NMEA 2000 Network DevicesYou can view the devices connected to the NMEA 2000 network.1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > DeviceList.2. Select a device for a list of options.Selecting a Preferred Data SourceIf more than one data source is available, you can select the data source you want to use.1. From the Home screen, select Configure > Communications > Preferred Sources.2. Select a type of data.3. Select Change Source.4. Select a data source.