Garmin GPSMAP 190-01120-00 Owner's Manual

Also see for GPSMAP 6008: Technical reference Important safety information Supplement Owner's manual Declaration of conformity

Contents

Garmin GPSMAP 190-01120-00 Owner's Manual Manual pdf 63 page image

GPSMAP® 6000/7000 Series Owner’s Manual 7Device ConfigurationDevice ConfigurationBasic Device Configuration QuestionsQuestion AnswerHow do I adjust the amount of detail shown on themap?See “Changing the Map Zoom Detail” (page 11).How do I change the time zone setting? See “Configuring the Time” (page 61).How do I change the language setting? See “Setting the Language” (page 58).How do I adjust the brightness of the backlight? See “Adjusting the Backlight” (page 3).How do I show a compass tape at the top of the chart? See “Showing the Compass Tape Data Bar” (page65).How do I change the color of the active track? See “Setting the Color of the Active Track” (page 39).How do I delete the track log on the map? See “Clearing the Active Track” (page 41).How do I transfer waypoints to a memory card? See “Chartplotter Data Management” (page 69).How do I erase all waypoints, route, and tracks? See “Deleting All Saved Waypoints, Routes, andTracks” (page 41).How do I check the software version and the mapversion on the chartplotter?See “Viewing System Information” (page 4).Simulator Mode WARNINGDo not try to navigate using simulator mode because the GPS receiver is turned off. Any satellitesignal strength bars shown are simulations and do not represent the strength of actual satellitesignals.Simulator mode turns the GPS receiver off for use indoors or for practice using the chartplotter. Thechartplotter does not track satellites in simulator mode.Turning Simulator Mode OnFrom the Home screen, select Configure > System > Simulator > on.Configuring Simulator Mode1. From the Home screen, select Configure > System > Simulator > Setup.2. Complete an action:Select Speed. For the GPSMAP 6000 series, use the Rocker or the Numeric Keypad to enterthe speed of your boat in simulator mode. For the GPSMAP 7000 series, use the on-screenkeyboard. Select Done.Select track Control. Select Auto track to allow the chartplotter to set the headingautomatically, or select User track to set the heading manually.Select Set Position. For the GPSMAP 6000 series, use the Rocker to select the simulatedposition of your boat. For the GPSMAP 7000 series, touch the navigation chart. Select Select.Select Set time. For the GPSMAP 6000 series, use the Rocker or the Numeric Keypad toenter the time. For the GPSMAP 7000 series, use the on-screen keyboard. Select Done.Select Set Date. For the GPSMAP 6000 series, use the Rocker to enter the date. For theGPSMAP 7000 series, use the on-screen keyboard. Select Done.•••••