Garmin NavTalk NavTalk GSM Owner's Manual

Also see for NavTalk: Owner's manual Command reference Owner's manual and reference guide

Contents

103Section 4Appendix CSection 6The unit uses “pop-up” messages to alert you to unit operat-ing characteristics. Press the ENTER or any other keypad keyto acknowledge and return to the page you were viewing.Address Buffer Full - Try Entering a City or Zip CodeAppointment Memory Full - Delete old data to allow spacefor new data.Approaching Turn - You are less than one minute away froma turn in route.Arriving at Destination - You have reached your destination.Auto-Redial Timer Not Ready - Wait for the timer to reset.Basemap Failed - The base map has failed. Return unit toGARMIN for service.Batteries Low - The batteries in your unit are low. Rechargebattery.Batteries Too Low TX Disabled - The battery in your unit islow and no longer capable of supporting unit phone operation.Recharge battery.Blackjack - You have reached 21 points.Blacklist Full - The list of blacklisted numbers is full. Turn theunit Off then On to reset the list.Bookmark Memory Full - Delete old data to allow space fornew data.Call Barred - An incoming call has been barred.Call Barring ON - Acknowledgement that at least one CallBarring feature is now active.Call Cost Not Available - Contact your service provider to setup this feature.Call Diverted - The incoming call has been diverted.Call Diverted, ON - Acknowledgement that a Call Divertfeature is currently active.Call Failed - The outgoing call did not connect.Call Service Activation OK - Confirmation that a Call Serviceis now active.Call Service Active - When checking the status of a CallService, this message reports “Active”.Call Service Action Aborted - A Call Service action has beenaborted from the “Working” page.Call Service Action Failed - The initiated action has failedbecause you have not subscribed to that service or there arenetwork communication problems. If the service is active, tryagain later.Call Service Action OK - (USSD), Unstructured Supplemen-tary Service Data action has been accepted. See your serviceprovider for details.Messages