Part No. 65196 Genie S-60 & Genie S-65 4 - 75Third Edition • First Printing Section 4 • Scheduled Maintenance ProceduresE-2Change or Recondition theEngine Coolant -Liquid Cooled ModelsReplacing or reconditioning the engine coolant isessential to good engine performance and servicelife. Old or dirty coolant may cause the engine toperform poorly and continued use may causeengine damage. Extremely dirty conditions mayrequire coolant to be changed more frequently.Bodily injury hazard. Beware ofhot engine parts and coolant.Contact with hot engine partsand/or coolant may cause severeburns.Perform this procedure with theengine off and cooled.1 Remove the 2 engine pivot plate retaining bolts.Swing the engine pivot plate away from themachine to access the cooling system.a engine pivot plateb pivot plate retaining boltsc air baffle2 Put on protective clothing and eye wear.3 Disconnect the coolant return hose at theradiator and drain the coolant return tank into asuitable container.4 Slowly remove the radiator cap from theradiator.Bodily injury hazard. Allow anypressure to dissipate graduallybefore removing the radiator cap.5 Open the drain valve on the radiator and allowall the coolant to drain into a suitable container.6 After all the coolant has drained, close the drainvalve. Connect the coolant return hose tothe radiator.7 Open the drain valve on the engine block andallow the coolant to drain into a suitablecontainer. After the fluid has drained, close thedrain valve.8 Replace all coolant hoses and clamps.9 Fill the radiator with the proper coolant mixture(coolant and water) for your climate until it isfull.10 Fill the coolant recovery tank to the NORMALrange.11 Clean up any coolant that may have spilledduring this procedure.12 Start the engine from the ground controls andlet it run for 30 seconds. Turn the engine offand inspect for leaks.a b cbTABLE E PROCEDURES
