Part No. 65196 Genie S-60 & Genie S-65 4 - 69Third Edition • First Printing Section 4 • Scheduled Maintenance Procedures3 Remove the fuel pump cover retaining fastener.Remove the cover.4 Gently clean the fuel strainer with clean dieselfuel or a mild solvent.5 Install the fuel strainer and pump cover onto thefuel pump. Install and tighten the fuel pumpcover retaining fastener.6 Turn the manual fuel shutoff valve, located atthe fuel tank, to the OPEN position.7 Start the engine from the ground controls andinspect the fuel filter for leaks.Explosion and fire hazard. If a fuelleak is discovered, keep anyadditional personnel from enteringthe area and do not operate themachine. Repair the leakimmediately.Be sure the fuel filter is full of fuelbefore attempting to start theengine.D-9Replace the Diesel FuelFilter/Water Separator -Deutz Diesel ModelsReplacing the diesel fuel filter/water separator isessential to good engine performance and servicelife. A dirty or clogged filter/water separator maycause the engine to perform poorly and continueduse may cause component damage. Extremelydirty conditions may require that the filter/waterseparator be replaced more often.Explosion and fire hazard. Enginefuels are combustible. Replace thefuel filter/water separator in anopen, well-ventilated area awayfrom heaters, sparks, flames andlighted tobacco. Always have anapproved fire extinguisher withineasy reach.Perform this procedure with theengine off.1 Turn the manual fuel shutoff valve, located atthe fuel tank, to the CLOSED position.TABLE D PROCEDURES
