SAFETY FEATURESSafe-T-Beam® (STB) Non-Contact Reversing SystemPuts an invisible beam across the door opening. The door stopsand reverses to the full open position if anythingthpassesrough the beam. LED indicator lights on the powerhead andon the STBs provide a self diagnostic code if an operationalproblem exists.Safe-T-Reverse® Contact Reversing SystemAutomatically stops and reverses a closing door within twoseconds of contact with an object.Automatic ForceGuard™ ControlAutomatically sets the force required to fully open and close thedoor for maximum safety.Watch Dog™ Monitoring SystemMonitors the Safe-T-Beam® system to ensure proper function-ality and will automatically stop and reverse a closing door if aproblem is detected.Manual Emergency ReleaseManually releases door from door opener. Used during a powerfailure or other emergency to allow manual opening and closingof door.SmartSet™ Electronic ProgrammingEasily adjust the programming to reduce opening speed to adesired rate, vary limits and force, and program new remotes.Automatic Lighting SystemTwo bulb lighting system supplies up to 200 Watts of light forsafer evening exits and entries. Turns ON when door is activatedand automatically turns OFF 4 minutes later.Integrated Motion Detection (Not available on all models)Select units have motion detection built into the powerhead.Lights automatically turn ON when motion is detected for muchsafer movement through the garage. Lights will turn OFF after4 minutes of no motion.3INTELLICODE® 2 Access Security SystemA new generation superior encryption system that enhancesthe securi ty of the door opener by continuously changing theaccess code each time the remote is used. The door openeresponds to each new code only once. An access code copiedfrom a working system and tried again will not control thedoor opener.OPENER FEATURESWall Console, Series IIIOperates door opener from inside garage. The Wall Console hasan Indicator Light with: Open/Close, Sure-Lock™, andIndependent Light Control buttons.©2011 The Genie Company 9/2011rTRANSMITTER COMPLIANCE STATEMENTTransmitters comply with all United States and Canadian legalrequirements as of the date of manufacture. No warranty is madethat they comply with all legal requirements of any other jurisdiction.If transmitters are to be used in another country, the importermust determine compliance with any local laws andwhich mregulationsay differ from United States and Canadian requirementsprior to use.Los transmisores cumplen con todas las reglamentaciones legalesde los Estados Unidos y del Canadá, en la fecha de fabricación.Ninguna garantía se da que cumplan con todas las reglamentacioneslegales de ninguna otra jurisdicción. Si los transmisores se van autilizar en otro país, el importador debe determinar si cumplen conlas reglamentaciones y leyes locales que puedan ser diferentes a lasreglamentaciones de los Estados Unidos y del Canadá, antes de usarlos mismos.Les émetteurs sont conformes à la réglementation américaine etcanadienne à compter de leur date de fabrication. Aucune garantien’est stipulée indiquant qu’ils sont conformes à toutes lesprescriptions juridiques d’autres autorités. Si les émetteurs sontutilisés dans d’autres pays, il incombe à l’importateur d’endéterminer leur conformité aux lois et règles locales pouvantdifférer de celles des États-Unis et du Canada avant toute utilisationdesdits émetteurs.Sendegeräte entsprechen allen gesetzlichen Bestimmungen in denUSA und Kanada zum Zeitpunkt der Herstellung. Wir übernehmenkeine Gewährleistung für die Einhaltung aller gesetzlichenBestimmungen in anderen Ländern. Sollen Sendegeräte in anderenLändern eingesetzt werden, so muss der Importeur vor demGebrauch sicherstellen, dass die Sendegeräte auch solchen lokalenBestimmungen entsprechen,welche von den Bestimmungen derUSA und Kanadas abweichen.and Car2U® compatible. Refer to the programminginstructions on page 6.HomeLink®