Genie SilentMax 1000 Operation & Maintenance Manual

Also see for IntelliG 1000: Manual Product guide Operation and maintenance manual Operation & maintenance manual Operation & maintenance manual

Contents

Genie SilentMax 1000 Operation & Maintenance Manual Manual pdf 9 page image

8©2011 The Genie Company9/2011s With the door closed, pull release handleDOWN and let go to release door carriage assemblyfrom drive system.sRsRaise and lower the door manually—it should movefreely and smoothly.’ dnateef4ot3yletamixorppayllaunamroodesialet go.– Door should remain stationary or move veryslowly.– If door moves quickly, CONTACT A TRAINEDDOOR SYSTEM TECHNICIAN.s#LOSETHEDOOr.s Verify RED block in carriage is in the up position.(refer to page 13)– Operate door using remote or wall console.– Door will re-attach itself to carriage assembly.Check that both the RED and GREEN LEDs are ON steady.This indicates the system is working properly. If both LEDsare not ON steady, check the appropriate items below.If the system appears to be working properly, perform thecheck as follows:1. Start the door closing.2. Pass on object through the beam, the door shouldstop and reverse to the fully open position.Perform the check as follows:DOOR BALANCE (SPRING TENSION)Safe-T-Beam® (STB) SYSTEM CHECKs34"2ED,%$FLASHES– Check for obstruction.– Check alignment.– Verify wire routing from STBs to STB connectionin powerhead.– Check for signal interferenceSafe-T-Beam® unit (For multiple door installations).from another.s.O34"2EDOR'reen LED displayed.– Check wiring and wire connections.MAINTENANCE & TROUBLESHOOTING3If you have any questions, please do not hesitate tocontact customer service at: 1-800-35-GENIE or visitIMPORTANT SAFETYINSTRUCTIONSWARNING: To reduce the riskof severe injury or death1. READ AND FOLLOW ALL INSTRUCTIONS.2. Never let children operate or play with the door controls.Keep the remote away from children.3. Always keep the moving door in sight and away from peopleand objects until the door is completely closed. NO ONE.ROODGNIVOMEHTFOHTAPEHTSSORCDLUOHS4. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.5. Test opener monthly. The door MUST reverse on contactwith a 1-1/2" high object (or a 2" x 4" board laid flat) at thecenter of the doorway on the floor. After adjusting either theforce or the limit of travel, retest the door opener. Failure toadjust the opener properly may cause severe injury or death.6. When possible, use the emergency release only when thedoor is closed. Use caution when using this releasedoor open with the. Weak or broken springs are capable of increasingthe rate of door closure and increasing the risk of severeinjury or death.7. KEEP DOORS PROPERLY BALANCED. See your garage doorOwner’s Manual. An improperly balanced door increases therisk of severe injury or death. Have a trained door systemtechnician make repairs to cables, spring assemblies, andother hardware.8. SAVE THESE INSTRUCTIONS.www.geniecompany.com.WARNINGs ,stekcarb,selbac,sgnirps(erawdrahroodegaraGpulleys, etc.) are under extreme pressure andtension.s DO NOT attempt to repair or adjust door springs orany hardware, and DO NOT OPERATE garage doorautomatically or manually if door is improperlybalanced or springs are broken.– CONTACT A TRAINED DOOR SYSTEM TECHNICIAN.ROUTINE MONTHLY MAINTENANCEBasic monthly maintenance tasks.s Safe-T-Beam® System Checks Door balans Lubricate Door Hardwareces Contact reverseWARNINGUse wall console supplied with opener. Other approved wallconsoles may be available. Unapproved or incompatible wallconsoles can cause the opener to operate unexpectedly.CONTACT REVERSESee page 5.TEST s Use silicone lubricant or lightweight oil.LUBRICATE DOOR HARDWARELubricate door rollers, bearings and hinges: