Genie SilentMax 1000 Operation & Maintenance Manual

Also see for IntelliG 1000: Manual Product guide Operation and maintenance manual Operation & maintenance manual Operation & maintenance manual

Contents

Genie SilentMax 1000 Operation & Maintenance Manual Manual pdf 5 page image

4©2011 The Genie Company9/2011SETPROGRAMOpen TravelROUND LEDIndicatorFacingGarage DoorCloseTravel ButtonOVERVIEW OF POWERHEAD CONTROLSThis section describes the simple programmingfunctions. Use this page to familiarize yourself with thebuttons and LED indicators used to program the opener.NOTE: These and buttons are for programming useonly. Do NOT use these buttons to operate the opener.There are three programming buttons and two lights(LEDs) on the powerhead.Each of the buttons are used to enter and completethe setup programming. The LEDs indicate status or afunction change by illuminating ON, OFF, or ON flashingin one of three different colors: BLUE, RED, or PURPLE.PROGRAMSETEnters into and selects programming menus.Programming OverviewThere are four Powerhead program menus:Remote Program (Default menu)Limits ProgramSpeed Program**Force Program** Force settings are set at the factory and do not normallyrequire operator programming but can require minor** Speed settings are set at the factory and are self-adjusting when needed. Speed Settings do not normallyrequire manually initiated changes.1Located on bottom of Powerhead.Begin here ONLY AFTERdnaylbmessagnitelpmocinstallation of the opener.Review the Assembly &Installation Poster toensure all steps havebeen performed.There are no assembly or installationsteps included in this manual. Contactyour Genie® Professional Dealer for aninstallation poster, if needed, or call1-800 35-GENIE. You may also visitwww.geniecompany.com to downloada pdf. file.Before you begin Programming,check to make sure there are noobjects in the garagedoor opening.INFRARED PROTECTION FUNCTION1. The Safe-T-Beam® has no effect on the doorduring an opening cycle.2. If the Safe-T-Beam® detects an obstructionwhen trying to close the door, it will not allowthe door to move.3. When the garage door is closing, if Safe-T-Beam®is interrupted by person or obstacle, the garagedoor will stop its downward travel and reverseautomatically to its fully opened position.4. If the Safe-T-Beam® System fails, loses power, oris installed improperly, press and hold the wallconsole "open/close" button until the doorreaches its fully closed position. If you release the"open/close" button on the wall console duringthe closing movement the door will reverseautomatically to its fully opened position.adjustment under certain conditions.See Troubleshooting.LONG LEDIndicatorMulti-function; move door during programming& advance through menusBoth LEDs can be Red, Blue, Purple or off, depending on theprogramming step you are performing.ADJUSTMENT OF FORCE & SPEED SETTINGS IS ON PAGE 10IN THE MAINTENANCE & TROUBLESHOOTING SECTION.