46MIM/DMIM/XMIMH3C MSR router series uses modular design and supports a wide range of MIMs/DMIMs/XMIMs.These interface modules provide abundant interfaces, including synchronous/asynchronous serialinterface, Ethernet interface, E1/T1, ISDN BRI/PRI, audio interface, and Layer 2 switching interface.Among these MIMs/DMIMs/XMIMs, Ethernet switching modules MIM-16FSWP and DMIM-24FSWPare PoE capable. When installed on a PoE router, they can provide –48 VDC power to remote PDs(such as IP phone, WLAN AP, and network camera) through straight-through network cables.Ethernet switching module• MIM-16FSW• MIM-16FSWP• DMIM-24FSW• DMIM-24FSWP• DMIM-48FSW• XMIM-16FSW• XMIM-24FSWXMIM-16FSW/XMIM-24FSWIntroductionEach XMIM-16FSW provides 16 10/100 Mbps RJ-45 connector interfaces, while each XMIM-24FSWprovides twenty-four 10/100 Mbps RJ-45 connector interfaces. Both XMIM-16FSW andXMIM-24FSW are suitable for a small enterprise network to serve as a switching and routing device,which can be directly connected to PCs and network devices of the enterprise. XMIM-16FSW andXMIM-24FSW support the following functions:• A transmission distance of 100 m (328.08 ft) when connected with a category-5 twisted paircable (crossover or straight-through cable).• 100 Mbps wire-speed forwarding between any ports when connected with a category-5 twistedpair cable (crossover or straight-through cable).• Autosensing at a rate of 10 Mbps or 100 Mbps.• Full duplex and half duplex, of which full duplex is common.
