50Table 66 Description for the DMIM-24FSW/DMIM-24FSWP GE interface LEDsLED status DescriptionOff No link is present.Steady green A gigabit link is present, but no data is being transmitted and received.Flashing green A gigabit link is present and data is being transmitted and received (ACT).Steady yellow A 100 Mbps link is present, but no data is being transmitted and received.Flashing yellow A 100 Mbps link is present and data is being transmitted and received (ACT).Table 67 Description for the DMIM-24FSW/DMIM-24FSWP fiber port LEDsLED status DescriptionOff No link is present.Steady green A link is present, but no data is being transmitted and received.Flashing green A link is present and data is being transmitted and received (ACT).Steady yellow Error promptThe MIM-16FSWP and DMIM-24FSWP interface modules each also provide a PoE LED to indicatethe PoE status.NOTE:The two GE interfaces on the DMIM-24FSWP do not support PoE.Interface cables and the connection methodsFor more information about the Ethernet interface cables and the connection methods, see "Ethernetinterface."For more information about transceiver modules, optical fibers, and the connection methods, see"Fiber port."DMIM-48FSWIntroductionThe 48-port Ethernet Layer 2 switching MIM interface module (DMIM-48FSW) can be installed onthe MSR 30 routers. Each DMIM-48FSW provides 46 ordinary 10/100 Mbps RJ-45 connectorinterfaces and two 10/100/1000 Mbps RJ-45 connector copper ports. DMIM-48FSW is suitable for asmall enterprise network to serve as a switching and routing device, which can be directly connectedto PCs and network devices of the enterprise. DMIM-48FSW supports the following functions:• A transmission distance of 100 m (328.08 ft) when connected with a category-5 twisted paircable (crossover or straight-through cable).• Wire-speed forwarding between any ports when connected with a category-5 twisted pair cable(crossover or straight-through cable).
