H3C S12500 Installation Instructions Manual

Also see for S12500 Series: Installation guide Quick start guide Software Upgrade Configuration Examples Interface configuration guide

Contents

4-6Board steady testing... [ PASS ]Board SlotNo... [ 1 ]Subcard exist testing... [ FAIL ]DX246 testing... [ PASS ]PHY88E1111 testing... [ PASS ]CPLD1 testing... [ PASS ]CPLD2 testing... [ PASS ]NS16550 register testing... [ PASS ]The default switch's Mac address... [00:e0:fc:00:95:12]CF Card testing... [ PASS ]BootWare Validating...Press Ctrl+B to enter extended boot menu...# After self-testing, the switch boots the applications. The following information appears on the terminalscreen (only part of the display information is given in this example):Starting to get the main application file--flash:/switch.bin!The main application file is self-decompressing.........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................Done!System is starting...Starting application at 0x00100000 ...TLB init OK.LBC init OK.LAW init OK.Bsp init start...MMU init OK.CRC init OK.Frame data init OK.Connect IRQ 0 OK.Enable IRQ 0 OK.Connect IRQ 1 OK.Enable IRQ 1 OK.Connect IRQ 2 OK.Enable IRQ 2 OK.Connect IRQ 4 OK.Enable IRQ 4 OK.Connect IRQ 5 OK.Enable IRQ 5 OK.Connect IRQ 6 OK.After the switch completes booting the applications, the following information appears on the terminalscreen:Press ENTER to get started.Press Enter to begin configuring the switch at the prompt: