H3C S3100 Series Command Manual

Also see for S3100 Series: Configuration Command manual Operation manual Installation manual Command manual

Contents

H3C S3100 Series Command Manual Manual pdf 43 page image

Command Manual (For Soliton) – Stack-ClusterH3C S3100 Series Ethernet SwitchesChapter 2 HGMP V2 ConfigurationCommands2-35of the shared FTP server configured on the management device takes effect on themanagement device only and will not be applied to the member devices through thecluster management packets.After the IP address of the shared FTP server is configured, network addresstranslation (NAT) is enabled on the management device immediately. When a memberdevice uses the ftp cluster command to access the shared FTP server, themanagement device will translate the private IP address of the member device to apublic network address, forward the requests of the member device to the FTP server,and forward the responses of FTP server to the member device according to the NATrecord.Examples# Configure FTP server 1.0.0.9 on the management device of a cluster. system-viewSystem View: return to User View with Ctrl+Z.[aaa_0.Sysname] cluster[aaa_0.Sysname-cluster] ftp-server 1.0.0.92.3.16 holdtimeSyntaxholdtime secondsundo holdtimeViewCluster viewParametersseconds: Neighbor information holdtime in seconds, ranging from 1 to 255.DescriptionUse the holdtime command to configure the neighbor information holdtime of themember switches.Use the undo holdtime command to restore the default holdtime value.By default, the neighbor information holdtime is 60 seconds.Note that:z If the management switch does not receive NDP information from a memberdevice within the holdtime, it sets the state of the member device to “down”. Whenthe management device receives the NDP information from the device again, thedevice will be re-added to the cluster automatically.