113parameter 1.3.6.1.2.1.16.1.1.1.4.1, where 1 indicates the serial number of the interface statistics entry.Therefore, if you execute the rmon statistics 5 command, you can use etherStatsOctets.5 to replace theparameter.The above configuration implements the following:• Sampling and monitoring interface GigabitEthernet1/0/1• Obtaining the absolute value of the number of received packets. If the total bytes of the receivedpackets reach 5,000, the system will log the event; if the total bytes of the received packets are nomore than 5, the system will take no action.rmon eventSyntaxrmon event entry-number [ description string ] { log | log-trap log-trapcommunity | none | traptrap-community } [ owner text ]undo rmon event entry-numberViewSystem viewDefault level2: System levelParametersentry-number: Specifies the event entry index, which ranges from 1 to 65,535.description string: Specifies the event description, a string of 1 to 127 characters.log: Logs the event when it occurs.log-trap log-trapcommunity: Specifies the log and trap events. The system performs both logging andtrap sending when the event occurs. log-trapcommunity indicates the community name of the networkmanagement station that receives trap messages, a string of 1 to 127 characters.none: Performs no action when the event occurs.trap trap-community: Specifies the trap event. The system sends a trap with a community name when theevent occurs. trap-community specifies the community name of the network management station thatreceives trap messages, a string of 1 to 127 characters.owner text: Specifies the owner of the entry, a case-sensitive string of 1 to 127 characters that can containspaces.DescriptionUse the rmon event command to create an entry in the RMON event table.Use the undo rmon event command to remove a specified entry from the RMON event table.When creating an event entry, you can define the actions that the system takes when the event istriggered by its associated alarm in the alarm table. The system can log the event, send a trap, do both,or do neither based on your configuration.Related commands: display rmon event, rmon alarm, and rmon prialarm.
