55Use the undo info-center snmp channel command to restore the default channel to output systeminformation to the SNMP module.By default, output of system information to the SNMP module is enabled with a default channel name ofsnmpagent and a default channel number of 5.For more information, see the display snmp-agent command in the chapter “SNMP configurationcommands.”Examples# Output system information to the SNMP module through channel 6. system-view[Sysname] info-center snmp channel 6info-center sourceSyntaxinfo-center source { module-name | default } channel { channel-number | channel-name } [ debug { levelseverity | state state } * | log { level severity | state state } * | trap { level severity | state state } * ] *undo info-center source { module-name | default } channel { channel-number | channel-name }ViewSystem viewDefault level2: System levelParametersmodule-name: Specifies the output rules of the system information about the specified modules. Forinstance, if information on the ARP module is to be output, you can configure this argument as ARP. Youcan use the info-center source ? command to view the modules supported by the device.default: Specifies the system information output rules for all the modules that can output systeminformation, including all the modules displayed by the info-center source ? command.debug: Specifies debugging information.log: Specifies log information.trap: Specifies trap information.level severity: Specifies the severity of system information. For more information, see Table 10. With thiskeyword, you can specify the severity level of the information allowed/denied to output.state state: Configures whether to output the system information, which could be on (enabled) or off(disabled). With this keyword, you can specify whether to output the specified system information.channel-number: Specifies a channel number, which ranges from 0 to 9.channel-name: Specifies a channel name, which could be a default name or a self-defined name. Theuser needs to specify a channel name first before using it as a self-defined channel name. For moreinformation, see the info-center channel name command.DescriptionUse the info-center source command to specify the output rules of the system information.Use the undo info-center source command to remove the specified output rules.
