104rpr admin-requestSyntaxrpr admin-request { fs | idle | ms } { ringlet0 | ringlet1 }ViewLayer 2 RPR logical interface view, Layer 3 RPR logical interface viewDefault level2: System levelParametersfs: Sends a forced switch (FS) protection request.idle: Sends an idle protection request.ms: Sends a manual switch (MS) protection request.ringlet0: Sends a protection request on Ringlet 0.ringlet1: Sends a protection request on Ringlet 1.DescriptionUse rpr admin-request to send an RPR protection request on the specified ringlet.By default, idle protection applies.The following types of protection requests, Forced Switch (FS), Manual Switch (MS), and idle, areavailable with decreased priorities. Among them, FS and MS requests are sent manually.• Use the rpr admin-request fs command to send an FS protection request. As the FS request takespriority over all other requests, you can remove it from the RPR ring only with the rpr admin-requestidle command.• Use the rpr admin-request ms command to send an MS protection request. As the priority of the MSrequest is the lowest, RPR ring does not perform MS switching if any other type of protection requestis present. On the contrary, the FS, SF, or SD request can override the MS request.• Use the rpr admin-request idle command to clear the FS or MS protection request.Examples# Configure Layer 2 RPR logical interface RPR-Bridge 1 to send an FS protection request on Ringlet 0. system-view[Sysname] interface rpr-bridge 1[Sysname-RPR-Bridge1] rpr admin-request fs ringlet0# Configure Layer 3 RPR logical interface RPR 1 to send an FS protection request on Ringlet 0. system-view[Sysname] interface rpr 1[Sysname-RPR1] rpr admin-request fs ringlet0rpr bindSyntaxIn Layer 2 or Layer 3 RPR logical interface view:
