82display rpr defectSyntaxdisplay rpr defect [ { rpr | rpr-bridge } interface-number ] [ | { begin | exclude | include }regular-expression ]ViewAny viewDefault level1: Monitor levelParameters{ rpr | rpr-bridge } interface-number: Specifies an RPR logical interface by its type and number. If no RPRlogical interface is specified, this command displays the RPR defect information of the stationscorresponding to all the RPR logical interfaces on your switch. The value range for the interface-numberargument is 0 to 15.|: Filters command output by specifying a regular expression. For more information about regularexpressions, see Fundamentals Configuration Guide.begin: Displays the first line that matches the specified regular expression and all lines that follow.exclude: Displays all lines that do not match the specified regular expression.include: Displays all lines that match the specified regular expression.regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.DescriptionUse display rpr defect to display RPR defect information.Examples# Display the ring defect information for Layer 3 RPR logical interface RPR 1. display rpr defect rpr 1RPR defects on interface: RPR1Excess reserved rate defect: ringlet0: 0, ringlet1: 0Jumbo configuration defect: 0Maximum number of stations exceeded defect: 0Miscabling defect: ringlet0: 0, ringlet1: 0Protection mode configuration defect: 0Inconsistent topology defect: 0Topology instability defect: 0IP address duplicate defect: 0MAC address duplicate defect: 1In the output, the value 0 means that no defects are present and 1 means at least a defect is present.display rpr fairnessSyntaxdisplay rpr fairness [ { rpr | rpr-bridge } interface-number ] [ | { begin | exclude | include }regular-expression ]
