H3C S9500E Series Command Reference Manual

Also see for S9500E Series: Card Manual Command reference Configuration guide Quick start guide Security configuration guide

Contents

H3C S9500E Series Command Reference Manual Manual pdf 145 page image

135ViewSystem viewDefault level2: System levelParametersNoneDescriptionUse rrpp enable to enable RRPP protocol.Use undo rrpp enable to disable RRPP protocol.By default, RRPP protocol is disabled.To activate the RRPP domain, enable the RRPP protocol and the RRPP rings for the RRPP domain.After you enable enhanced IRF mode, the RRPP function is not supported. For more information aboutenhanced IRF mode, see IRF Configuration Guide.Related commands: ring enable.Examples# Enable the RRPP protocol. system-view[Sysname] rrpp enablerrpp ring-groupSyntaxrrpp ring-group ring-group-idundo rrpp ring-group ring-group-idViewSystem viewDefault level2: System levelParametersring-group-id: Specifies the RRPP ring group ID in the range of 1 to 8.DescriptionUse rrpp ring-group to create an RRPP ring group and enter RRPP ring group view.Use undo rrpp ring-group to delete an RRPP ring group.When removing a ring group, do that on the edge node first and then on the assistant-edge node. If youfail to follow the order, the assistant-edge node might fail to receive Edge-Hello packets and mistakenlyconsiders that the primary ring has failed.After a ring group is removed, all subrings in the ring group do not belong to any ring group.Related commands: domain ring and display rrpp ring-group.