Page 10For more information on the digital and voice dialer - See Digital Dialer and Voice Dialer.• The system continues to sound all alarms and flash the flashing light for 1-30 minutes after the alarm is activated.• After a 1-30 minute period, the sounder is turned off, and the alarm system resets itself. The console beeper stays on.If a zone is tripped after a reset, the sounder will again be activated, and the dialer will again dial out.At any time, the alarm system can be turned off at the console.Fire Alarm ActivatedWhen the fire alarm is activated by the smoke/fire detector(s), the alarm responds exactly as described under Burglar AlarmActivated, except:• The console display reads, "FIRE ALARM! ZONE NAME TRIPPED".• The sounder will activate in a 3 pulse temporal pattern to distinguish the fire alarm from the burglar alarm.The fire alarm takes priority over the burglar alarm, however, if a gas alarm is already active, it will not override the gas alarm.NOTE: If multiple alarm types occur, such as both Fire and Police, the display will alternate between the alarm types.Gas Alarm ActivatedWhen the gas alarm is activated, the alarm responds exactly as described under Burglar Alarm Activated, except:• The console display reads, "GAS ALARM! ZONE NAME TRIPPED".• The sounder will pulse on - off - on, then an extended off period to distinguish it from the burglar or fire alarm.The gas alarm takes priority over the burglar alarm, however, if a fire alarm is already active, it will not override the fire alarm.Emergency KeysEmergency alarm conditions can be activated through the console. These conditions (Fire, Police, and Auxiliary) are initiatedwith the simultaneous depression of two keys for approximately 1-second.NOTE: The Emergency keys are always armed. The Fire and Auxiliary emergency alarms are silenced by pressing the ' * ' key.To cancel a Police emergency alarm you must press the Off key and enter your code.