Media-Mate Plus Operation Manual 25-710-800-OSection One – Safety ConsiderationsGeneral1. The Instrument should be on its own circuit to prevent problems and circuit overload.2. Never work on the electrical components in the system while there is power to theInstrument. Disconnect power: Do not run Instrument with the protective coverremoved from the electrical control cabinet.3. Do not fill the tank through the filter port on the tank; the Instrument may not handle theback-pressure.4. Review all safety and environmental precautions pertaining to any chemicals that are tobe used in conjunction with this Instrument.Safety MarkingsFor your own safety, you must observe the following safety warning signs. The safety warningsigns indicate a possible source of danger and provide preventative information.Sign Location Safety WarningControl Panel Caution! Keep media and other liquids away from thecontrol panel and away from all electrical components.Control Panel Caution! Do not press start switch until indicator lightsare off.Control Panel Caution! Do not restart Instrument with liquid in flaskswithout consulting troubleshooting section.Interface PanelHeaterCaution: No operator-accessible parts inside. Referservicing to qualified personnel only. Risk of electricalshock. Do not open.Achtung: Es gibt keine vorn Benutzer zo wanendenTeile. Oberlassen Sie Reparaturen dem qualifiziertenService-fachmann. Hochspannung. Nicht öffnen.Attention: Aucune pièce remplaçable par l’utilisateur.Toute réparation doit être effectuée par un technicienqualifié. Risque d’ electrocution. Ne pas ouvrir.Interface Panel Caution! Turn Instrument off and remove power cordbefore replacing fuses. Fuses must be replaced withthe same current rating and type described next to thefuse holder.Heater Caution! Heater is hot; do not touch.Section 1 Safety Considerations 1