Hardi MARRO TWIN FORCE 1000 Instruction Book

48 GB 14 07 03ShocShocShocShocShock ak ak ak ak absorberbsorberbsorberbsorberbsorbersssssIf the shock absorbers does looses their efficiency orstarts leaking oil, they should be replaced.LeLeLeLeLevvvvvel indicael indicael indicael indicael indicator adjustmenttor adjustmenttor adjustmenttor adjustmenttor adjustmentThe level indicator reading should be checked regularly.When the tank isempty, the float shouldlie on the stop pin, ofthe rod, and the O-ringon the indicator shouldbe positioned at the topposition line A.If any deviation isfound, pull out the plugB, loosen screws C,and adjust the length ofthe cord.CorCorCorCorCord rd rd rd rd reneeneeneeneenewwwwwal, leal, leal, leal, leal, levvvvvel indicael indicael indicael indicael indicatortortortortorIf the cord on the level indicator has to be changed, thefloat guide pole is removed:1. Remove the tank drain valve (see paragraph ìMaintank drain valveî) and loosen the fitting holding thepole in position.2. Pull the pole down through the drain valve hole till it isfree in the top of the tank.3. The pole can now be taken out of the tank throughthe filling hole.DANGER! Do not attempt to enter the tank - thefloat pole can be removed from outside the tank!Seal rSeal rSeal rSeal rSeal reneeneeneeneenewwwwwal, dral, dral, dral, dral, drain vain vain vain vain valvalvalvalvalveeeeeIf the main tank drain valve leaks, the seal and seat canbe changed the following way.NOTE! Do not enter the inside of the tank - the parts canbe changed from underneath the tank!WARNING! Use eye / face protection mask whendismantling the tank drain valve!1. Make sure the tank is empty and clean.2. The valve must be closed and the string loose.3. Pull out the clip A and pull down connecting piece B.The entire valve assembly can now be pulled out.T191-00164. Check cord and valveflap assembly C forwear, replace seal Dand assemble again.5. Assemble the valveassembly again using anew valve seat E.Lubricate O-rings Fbefore assembly.6. Fit clip A again.NOTE! Check function ofvalve with clean waterbefore filling chemicals intothe tank!Air sleeAir sleeAir sleeAir sleeAir sleevvvvve re re re re reeeeepairpairpairpairpairIf the boom air sleeve should be torn, it can be mended.Clean the bag with a suitable solvent and mend it usingthe mending kit, Part No. 728746, which include glueand cloth.Light equipment, bLight equipment, bLight equipment, bLight equipment, bLight equipment, bulb rulb rulb rulb rulb reneeneeneeneenewwwwwalalalalalFollowing bulb renewal procedures:T191-0016evvirDp Axsh@4f G! S SGPI! IP IPGPIh IP IPGPIA$#@euiqDp Axsh@4f G! S SGPI! IP IPGPIh IP IPGPID! Aeuiq@ SGPIrp Axsh@4f G!v Rr SSGHTGPI! E RGPI$4#!##!4#p Axsh@4f G!%!!4D#S SGPIchart 020