Entering STANDARD Calibration ValuesOnce in calibration mode, you may change any one, all or none of thevalues, in any order. To enter calibration mode, simply turn the rotaryselector to the desired calibration position. Use the ADJUST switch toadjust values. Calibration positions are identified as RED with whitetype (lower six positions).Entering Standard CalibrationTo enter calibration, proceed as follows:1. Place the AUTO/MAN/HOLD switch in HOLD.2. Turn the rotary dial to any of the six (RED) calibration positions.The console will display CAL and the warning light will flash. SeeFigure 8.2.Fig. 8.2CALExiting System CalibrationUpon completion of the special calibration process, exit specialcalibration by simply pressing the SYSTEM CAL button. Proceed withStandard Liquid Calibration before beginning operation.Before beginning operation, refer to Test Speed and Pre-field SystemCheckout on pages 37 and 38. This will confirm your calibrationsettings, nozzle selection and overall system performance.HARDI MT-9000 OPERATOR’S MANUAL 34