997 - Fault findingOperational problemsGeneral infoOperational incidents are frequently due to the same reasons:1. A suction leak reduces the pump pressure and may interrupt suction completely, it also causes pulsing in the pressurehoses.2. A clogged suction filter may damage suction or interrupt and prevent the pump from running normally.3. A clogged pressure filter increases pressure in the fluid system in front of the pressure filter. This may blow the safetyvalve.4. Clogged In-line or nozzle filters increase pressure in the pressure gauge but decrease pressure at the nozzles.5. Impurities sucked by the pump may prevent the valves from closing correctly, thus reducing the pump flow.6. A poor reassembly of the pump elements, especially the diaphragm covers, causes air leaks and reduces the pumpflow.7. Rusted or dirty hydraulic components cause bad connections.8. A badly charged or faulty battery causes failures and misbehaviour in the electrical system.Therefore ALWAYS check1. Suction and pressure filters, as well as nozzles, are clean.2. Hoses for leaks and cracks, paying particular attention to suction hoses.3. Gaskets and O-rings are present and in good condition.4. Pressure gauge is in good working order. Dosage accuracy depends on it.5. Operating unit functions properly. Use clean water to check.6. Hydraulic components are clean.7. The good condition of the tractor battery and its connectors.
