Chapter 3. Diagnostics 11Product Recovery Program menuType 2254, 2256, 2257, 6336, 6337, 6339, 6341, 6342, 6346, 6347, 6348 machines haverecovery and diagnostics programs on a separate hard drive partition. The EnhancedDiagnostics diskette is not shipped with the machine or the HMM. To download theDiagnostics program, see “Diagnostics program download” on page 12.At startup, the machine displays the following prompt:To start the Product Recovery Program, press F11CAUTION:Make sure all data is backed up to avoid loss when the Product Recovery programis used.After depressing F11, you are given the following options.• IBM Backup and RestoreThis utility will restore your most recent backup of your operating system,applications, and data.Note: This item should only appear if the IBM Backup and Restore program hasbeen installed• Full recoveryThis utility reformats the hard drive and restores all original files.• System utilities1. Repair (Windows NT 4.0 and 2000 Only)This runs the Windows NT 4.0 emergency repair utility.2. Run DiagnosticsRuns the IBM Enhanced Diagnostic Program.3. Create a Diagnostics DisketteCreates a bootable diagnostic diskette.4. System InformationDisplays information about your computer configuration and allows the userto gather system information that would be needed during a Help Center call.5. Create Recovery/Repair Diskette (Disk to Disk Solution Only)Creates a startable diskette to restore access to the IBM Product Recoveryprogram on the hard disk.
