16 IBM : Hardware Maintenance ManualThe Full Erase Hard Drive provides a DOS utility that performs the following steps.• Performs all the steps in Quick Erase.• Provides a DOS utility that writes random data to all sectors of the hard drive.• Provide an estimate of time to completion along with a visual representation ofcompletion status.• Provides messages that warn the user about non-recoverable process.To select the Quick Erase or Full Erase Hard Drive utility, use the following procedure.1. Select the UTILITY option on the toolbar and press Enter.2. Select either the QUICK ERASE or FULL ERASE HARD DISK option and followthe instructions.Iomega Zip drive testUse the Iomega Zip Drive Test to test the Zip drive and the drive interface. The testtakes about 20 seconds to run.The default tests the following:• Controller• Max Seek (50 times)• Random Seek (300 sectors)Asset EEPROM backupWhen replacing a system board, this utility allows the backup of all Asset informationfrom the EEPROM to diskette. This utility also restores data to the EEPROM fromdiskette after replacement of the system board.To run this utility, use the following procedure.• Select Utility• Select Asset EEPROM Backup• Follow instructions on screen.Viewing the test logErrors reported by the diagnostic test will be displayed by the program as a failed test.To view details of a failure or to view a list of test results, use the following procedurefrom any test category screen.• Press F3 to activate the log file.• Press F3 again to save the file to diskette or F2 to print the file.Important: Make sure that all data is backed up before using the Quick or Full Erasefunctions.
