Installing a DVD (optical) driveReleasebuttonDVDbracketTo install a DVD drive, compete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 32.2. Turn off the server and peripheral devices, and disconnect the power cord andall external cables.3. Remove the front bezel.4. Push the blue release button above the DVD drive bay to remove the fillerpanel.5. Pull the bracket off the filler panel.6. Install the bracket on the side of the DVD drive.7. Slide the DVD drive into the server until it engages the SATA cable.8. Reinstall the front bezel.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 71.Installing a 2.5-inch hard disk drive backplaneTo install a 2.5-inch hard disk drive backplane, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 32.2. Turn off the server and peripheral devices, and disconnect the power cord andall external cables.3. Remove the server cover (see “Removing the top cover” on page 37).4. Remove the top cover bracket (see “Removing the top-cover bracket” on page38).5. Pull out the hard disk drives and hard disk drive fillers just enough todisconnect them from the backplane.6. Remove the ServeRAID adapter from behind the hard disk drive backplane.7. Disconnect the SAS signal cables from the ServeRAID adapter.8. Lift the SAS power and configuration cable handle up to disconnect the cablesfrom the microprocessor board.9. Slide the backplane carrier release tab forward and slightly lift the carrier.10. Remove the backplane carrier and SAS power cable handle from the servertogether.Chapter 2. Installing optional devices 49