10. Install the memory card.ReleaseleverMemorycard fillera. If this is a new memory card, remove the memory card filler from theserver.b. Insert the memory card into the memory-card connector.c. Press the memory card into the connector and close the release levers.d. Slide the blue release latch to the locked position.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 71.Installing a microprocessorThe following notes describe the type of microprocessor that the server supportsand other information that you must consider when you install a microprocessor:v The optional microprocessors that IBM supports are limited by the capacity andcapability of the server. Any microprocessors that you install must have the samespecifications as the microprocessors that came with the server.v For a list of supported optional devices for the server, see http://www.ibm.com/servers/eserver/serverproven/compat/us/.v The server supports up to four Intel Xeon microprocessors. If you are installingtwo or more microprocessors, they must be the same cache size and type, andthe same clock speed.v The server can operate as a symmetric multiprocessing (SMP) server. With SMP,certain operating systems and application programs can distribute the processingChapter 2. Installing optional devices 67