IBM E Server i Series Manual

Also see for E Server i Series: Setting up Manual Manual

8. Click Apply. If prompted, insert your Windows Setup CD-ROM.9. Click OK to restart the PC.Install or configure Remote Access Service (NT only)Make sure that you install and set up Remote Access Service according to yourintended configuration. You only need to install Remote Access Service if you areusing Windows NT. You are going to add and configure the modems needed foryour configuration even if you are not installing Remote Access Service.Important:v You must have your Windows NT Setup CD-ROM available.v You will need to install Remote Access Service before installing Windows NTservice pack.To install or configure Remote Access Service:1. Open the Network folder by doing the following:__ a. Click Start and select Settings.__ b. Click Control Panel.__ c. Double-click Network.2. Click the Services tab.3. Do one of the following:v If Remote Access Service is listed, do the following:a. Select Remote Access Service; then, click Properties.b. Continue with step 4.v If Remote Access Service is not listed, follow these instructions to install:a. Put the Windows NT CD into the optical device drive (for example, aCD-ROM drive), unless installing from a network drive.b. Click Add.c. Select Remote Access Service and click OK.d. Set the path the Windows NT files will be read from, then clickContinue. When the necessary files have been copied, the Add RASDevice window should appear. Read step 4, then, continue with step 5b.4. Using Table 1, identify the correct modems that you need to add in RemoteAccess Service for your Operations Console configuration.Important: You may have to add more than one modem in Remote AccessService to satisfy your intended configuration.Under certain circumstances, such as when installing Windows NT andRemote Access Service, you may have had to install a nonexistent modem. Ifso, any modem you intend to use with Operations Console may not show upin the Add RAS Device window even though it was previously installed. Inthese cases, you will need to Remove the previously installed modem fromRemote Access Service, and later from the Modems folder, since it may be onthe same COM port. In this way, the intended modem is made available to beselected. Remote Access Service does not allow more than one modem for thesame COM port.Table 1. Modems for Operations Console configurations for Windows NTDesired configuration Necessary modemsLocal console directly attached to the server AS400 Operations Console connection¹54 iSeries: iSeries Access for Windows Operations Console