IBM E Server i Series Manual

Also see for E Server i Series: Setting up Manual Manual

Reset the service tools device ID password on the PCReset the service tools device ID password on the PC by doing one of thefollowing:v To delete the configuration and re-create it, follow these steps:1. If connected, disconnect as follows:a. Select the configuration name (under iSeries Connection). This is thename that Operations Console uses to refer to a specific system.b. From the Connection menu, click Disconnect. The connection statusshows Disconnecting .c. Wait for the status to show Not connected to local console orDisconnected.2. Delete the configuration:a. Select the configuration name (under iSeries Connection) that you wantto delete.b. From the Connection menu, click Delete.c. Click Yes to confirm the deletion.3. Re-create the configuration with the service tools device ID password youpreviously reset or with the new service tools device ID.v To change or reset the password for the same service tools device ID, follow oneof these steps:– To use the connection properties to change or reset the service tools device IDpassword, follow these steps:1. Select the connection name that you will be making the change for, andthen click Connection —> Properties.2. Select the Device ID tab.3. Enter the appropriate password in the Passwordand Confirmpasswordfields, and then click OK.4. The Access Password window will appear. Enter the current accesspassword, and then click OK.– To use the configuration wizard to change or reset the service tools device IDpassword, follow these steps:1. Select the connection name that you will be making the change for, andthen click Connection —> Configure Connection.2. Accept the values on each window and continue into the wizard until youget to the Specify Service Device ID window.3. Enter the appropriate password in the Password and Confirm passwordfields, and then click Next.4. The Access Password window will appear. Enter the current accesspassword, and then click OK.5. Continue through the wizard to the last window and click Finish torewrite the data and exit the wizard.Create service tools device IDs on the serverYou need to set up service tools device IDs on the server for a local console on anetwork configuration:1. Access Dedicated Service Tools (DST).2. Select Work with DST environment.3. Select Service tools device IDs.92 iSeries: iSeries Access for Windows Operations Console