Option problemsOption problems ActionAn IBM option that was justinstalled does not work.Verify that:1. The option is designed for your computer.2. You followed the installation instructions suppliedwith the option and in “Chapter 5. Installing options”on page 43.3. All option files (if required) are installed correctly. See“Installing files from option diskettes” on page 97 forinformation about installing option files.4. You have not loosened any other installed options orcables.5. If the option is an adapter, you have provided enoughhardware resources for the adapter to functioncorrectly. See the documentation supplied with theadapter (as well as the documentation for any otherinstalled adapters) to determine the resourcesrequired for each adapter.6. You updated the configuration information in theprogram, if necessary, and have no conflicts. For moreinformation, see “Chapter 4. Using theConfiguration/Setup Utility program” on page 29.If the problem persists, run the diagnostic programs. (See“IBM Enhanced Diagnostics program” on page 94 forinformation about diagnostic programs provided withyour computer.)If you cannot correct the problem, have the computerand the option serviced.Chapter 6. Troubleshooting 91
