Table 3-2 (Page 7 of 9). Firmware Error Codes.Error Code Description Action/Possible Failing FRUxxx=001 DIMM fails memory test. For more information:1. Use the location code obtainedfrom the SMS Error Log utility(described in “Step 1020-4” onpage 2-11) to identify which DIMMis defective.2. The "yy" values specify type ofmemory causing error. See“Memory PD Bits” on page 3-13 fordefinition of "yy."Note: On the Model 240, there maybe 2 DIMM related memory errorsreported to indicate a DIMM pair. Oneof the 2 indicated DIMMs may be good,when replacing memory on this systemreplace 1 DIMM at a time, not both.xxx=002 DIMM is not supported. Remove unsupported DIMM.The "yy" values specify type of memorycausing error. See “Memory PD Bits”on page 3-13 for definition of "yy."Note: Memory DIMMs must beinstalled/removed in pairs on the Model240.28030xxx Real-time clock (RTC) error. Note: Errors reported against the RealTime Clock can be caused by lowbattery voltage and (more rarely) poweroutages that occur during normalsystem usage. These errors arewarnings that the Real Time Clock datacontent needs to be re-established anddo not require any FRU replacementunless the error is persistent. Whenone of these errors occurs, thepower-on password and time and dateinformation have been lost. To set/restore a power-onpassword, use the SMS utility. To set/restore the time and date,use the operating system facility.If the error is persistent, replace thebattery.If the error is persistent after batteryreplacement, replace the system board.(See notes on page 3-1.)3-10 7043 43P Series Service Guide
