Enter PasswordPress Enter when you are finished; you must type the password again forverification.Verify PasswordIf you make a mistake, press the Esc key and start again.Note: If an error occurs when you attempt to set the privileged-access password,then make sure the password-enabling jumper has been changed. (See theUser's Guide for instructions on changing the password-enabling jumper.)After you have entered and verified the password, the privileged-access passwordicon flashes and changes to the locked position to indicate that your system unit nowrequires the password you just entered before running system programs.Attention: Once the password-enabling jumper has been changed and theprivileged-access password has been set, great care must be taken topreserve the privileged-access password. If you set the privileged-accesspassword and later misplace it, your system must be returned for service.In order to prevent loss of system use, please record the privileged-accesspassword immediately whenever it is changed.Attention: If no user-defined boot-list exists, and the privileged-access passwordhas been enabled, you are asked for the privileged-access password atstartup every time you boot up your system.Moving the password-enabling jumper back to the default position does not disableor erase the privileged-access password. Removing the jumper or moving thejumper back to the default position only prohibits changing or disabling this passwordwith the System Management Services.7-16 7043 43P Series Service Guide
