10. Connect any required cables to the adapter.11. Install the PCI riser-card assembly (see “Installing the PCI riser-card assembly”on page 68).If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 68.Installing a ServeRAID SAS/SATA controllerNote: You must install a ServeRAID controller in expansion slot 4 on the PCIriser-card assembly.To install a ServeRAID controller, complete the following steps:1. Read the safety information that begins on page v and “Installation guidelines”on page 28.2. Turn off the server and peripheral devices, and disconnect the power cords andall external cables.3. Remove the server cover (see “Removing the top cover” on page 37).4. Remove the PCI riser-card assembly (see “Removing the PCI riser-cardassembly” on page 38).5. Touch the static-protective package that contains the new ServeRAID controllerto any unpainted metal surface on the server. Then, remove the ServeRAIDcontroller from the package.6. If you are installing a new or replacement ServeRAID controller that uses abattery, complete the following steps:a. Remove the battery from the ServeRAID controller package or the batterypackage.b. Install the battery and connect the battery to the ServeRAID controller asinstructed in the documentation that comes with the ServeRAID controller orthe battery, or see “Installing a ServeRAID controller battery on the remotebattery tray” on page 45.7. Install the ServeRAID controller.a. Install the 2U low-profile bracket to the ServeRAID controller (if it is notinstalled).Chapter 2. Installing optional devices 43