Chapter 4. Configuring your server 19The following table describes the choices available from the Advanced menu.Primary menu Item submenu Item value DescriptionBoot Configuration Plug & Play O/S [No] Yes Configures boot settings. Ifthe operating systemsupports Plug and Playoperation, set this value toYes.Reset Config Data [No] Yes Resets the configuration dataafter a restart operation.Numlock [Off] On Locks the number keypad.ADM GraphicsMode[Disabled] Enabled Enables or disables the ADMgraphics mode.PeripheralConfigurationSerial Port A [Auto]EnableDisableDetermines serial port Aconfiguration at startup.Auto Automaticallydetermine the baseI/O address andinterrupt to use forthe port.Enable Requires you tosupply the base I/Oaddress and theinterrupt value.Disable Causes the serverto disable the port.Serial Port B [Auto]EnableDisableDetermines serial port Bconfiguration at startup.Auto Automaticallydetermine the baseI/O address andinterrupt to use forthe port.Enable Requires you tosupply the base I/Oaddress and theinterrupt value.Disable Causes the serverto disable the port.Parallel Port [Auto]EnableDisableDetermines parallel portconfiguration at boot time.Auto Causes the serverto determine thebase I/O addressand interrupt to usefor the port.Enable Requires you tosupply the base I/Oaddress and theinterrupt value.Disable Causes the serverto disable the port.
