IDS 816 User Manual

Also see for 816: Installer manual User manual

IDS 816 User Manual Manual pdf 11 page image

IDS816 User Manual 700-283-01H Issued January 2009116.3.16.3.16.3.16.3.1 How to Stay AHow to Stay AHow to Stay AHow to Stay Armrmrmrm[#] [USER CODE](Do not leave premises)1. Select the required STAY PROFILE (See page 19)2. Ensure that the READY indicator is on. If not, check that all protected doors and windows areclosed and that all movement has ceased in the areas covered by motion detectors.3. Press the [#] key.4. Enter a valid [USER CODE]. If an incorrect code is entered, the keypad will give an error beep. Inthe event of an error press the [#] key and re-enter the [USER CODE].5. The ARMED indicator will come on and the keypad buzzer will sound for the duration of the exitdelay.6. DO NOT violate the Entry/Exit zone (normally the front door). If the Entry/Exit zone is violated thesystem will arm in the AWAY mode.7. Upon expiry of the exit delay, the AWAY indicator will remain off.8. Any STAY zones will be automatically bypassed (indicated by a steadily on indicator).9. Ensure that you enter only those areas that are bypassed.6.46.46.46.4 Quick Stay ArmQuick Stay ArmQuick Stay ArmQuick Stay ArmHold down the [5] key until the beepIt is possible to STAY arm by holding down the [5] key until the keypad buzzer sounds. The panel willimmediately arm into the stay mode without any exit delay. All stay zones will be bypassed.NNNNOTEOTEOTEOTE::::Holding the button down again will cause the panel to toggle between stay profiles. This STAY profilethen becomes the active profile and the panel will STAY arm using this profile - until you elect to switchprofiles again.6.4.16.4.16.4.16.4.1 How to Stay ArmHow to Stay ArmHow to Stay ArmHow to Stay Arm and Goand Goand Goand GoHold down the [6] key until the beepThis is a single key arm function that allows the user to STAY arm and leave the premises. If a partition isalready stay armed, holding down the [6] key initiates an exit delay, thus allowing the user to leave thepremises without disarming. At the end of the exit delay, the partition will re-arm in the same stay profile itwas armed in before the [6] key was held down.1. Hold down the [6] key until the keypad buzzer sounds. The keypad buzzer will sound for theduration of the exit delay. Only leave via a designated exit route.2. At the end of the exit delay, the ARMED indicator will come on and the AWAY indicator will remainoff. All stay zones will be bypassed.NOTENOTENOTENOTE::::Holding down the [6] key until the keypad buzzer sounds also ensures an entry delay on entering thepremises.